引用:
原文由 ACC 於 2012-8-15 11:21 發表
請問ST30W工程模式呢??有人知道嗎??想查詢使用時數而已.
2012 Models : _ ST50 / GT50 / VT50
2011 Models : _X3 / S30 / ST30 / GT30 / VT30
2010 Models : _X24 / C2 / U2 / S2 / G20 / G25 / GT20 / GT25 / VT20 / VT25
Press and hold the {VOL -} button ON THE PLASMA TV.
按住不放電視機上的 VOL - 按鈕
Then press the {INFO} button on the remote control 3 times.
然後按三下遙控器上的 INFO 按鈕
"Start Adjustment Menu" message will be displayed followed
by the Service Menu after few seconds.
出現 "Start Adjustment Menu" 訊息之後數秒,就會出現下列工程模式選單
ADJUST {Picture Adjustment}
WB-ADJUST {White Balance Adjustment}
OPTION {Option Setting}
V-SUS {V-SUS Adjustment}
AGING
SRV-TOOL {Service Tool}
{1} & {2} buttons move through options
使用 [1] 與 [2] 按鈕切換選項
Press the {2} button once to select "SRV-TOOL".
按一次 [2],選擇 "SRV-TOOL"
Then press the {OK} button to access it.
按 [OK] 進入選單內容
Using the cursor keys, highlight the right side
of the last item "PTCT :00.00.00.00.00" :
使用方向鍵,反白顯示最後一個項目的右側內容:"PTCT :00.00.00.00.00"
Then press and hold the {MUTE} button for 3 seconds.
按著 [MUTE] 按鈕三秒
Time and Count will be displayed in red color:
就會以紅色顯示時間與計數
__TIME = Hours : Minutes of operation.
COUNT = Times the Plasma was powered on.
__TIME:開機操作時間
COUNT:電視打開電源次數
To exit, unplug the power cable.
拔掉電源線,離開工程模式
WARNING BY BRUZZI: The {VOL+} and {VOL-} buttons are used
to change values while in the Service Menu. Make sure not to touch
those buttons when navigating menus / sub-menus.
在進入工程模式之後,[VOL+] 與 [VOL-] 按鈕式用來更改參數之用,請小心不要誤觸,以免喪失保固。